Ideally, the module would be able to select from any .fxp within a sub directory via fader, listbox etc and be able to unload the previously loaded vst when a new one was loaded...
Maybe for Usine v6?
Load VST module
-
gurulogic
- Member
- Posts: 1019
As usual, I am thinking of new interesting ways to do things, and it came to mind that a module that could load a .saved fxp from disk which would load the correct VST in series with this 'loadvstmodule' which would be pre wired in place where you wanted the vst to insert.
Ideally, the module would be able to select from any .fxp within a sub directory via fader, listbox etc and be able to unload the previously loaded vst when a new one was loaded...
Maybe for Usine v6?
Ideally, the module would be able to select from any .fxp within a sub directory via fader, listbox etc and be able to unload the previously loaded vst when a new one was loaded...
Maybe for Usine v6?
-
gurulogic
- Member
- Posts: 1019
Instead of starting yet another post for my silly ideas...
Another idea I have is to quickly find VST pins.
The method I see working well for this would be that the last touched VST parameter would either highlight the output pin on the VST module in the patch or else change the colour of the fader in the VST parameter view.
This would speed up patching for me significantly as sometimes it can take some time to find the correct pin.
Also interesting, what if right clicking on a parameter in the VST parameter view could bring up a menu to automaticly connect a knob, fader or either with pass if change module?
Another idea I have is to quickly find VST pins.
The method I see working well for this would be that the last touched VST parameter would either highlight the output pin on the VST module in the patch or else change the colour of the fader in the VST parameter view.
This would speed up patching for me significantly as sometimes it can take some time to find the correct pin.
Also interesting, what if right clicking on a parameter in the VST parameter view could bring up a menu to automaticly connect a knob, fader or either with pass if change module?