BrainModular

Hello,

I regularly take notes of things that I would like to see modified or implemented in Usine. Here's my wishing list:-)
Please don't hesitate to tell me if ot's not a good idea to post so much demands in one topic...

- devices menu displays the device group name
- possibility to move the devices in the devices menu ; to sort them as needed, and also because Usine chooses by default the 1st device as output
- being able to drag and drop a switch into the grid and have access to on and off values (as fader in non-curve mode)
- being able to move a section in the grid by «affecting» the new location, rather than by sliding (complicated when long grid)
- in patch settings , having a «reduce patch» input; there are two minimize inouts but no reduce ("-" in header)
- being able to open several patches windows simultaneously (convenient for comparing, searching ...) > probably very complicated but we never know...
- an option to load samples in midi sampler in loop mode by default
- in audio samplers modules, a trigger when it comes to end, not only on restart; sometimes more useful than when restart > to change zone markers for example (when you have to trigger somthing before the loop recovery)
- already asked , but (for me) indispensable : the possibility to save presets lists
- an option to make the intensity of the LEDs proportional to the signal received
- a global option «ignore show rack/patch when active on grid»; sometimes useful to be able to observe a rack/patch by "scrolling" the grid without having the other ones shown
- mixer: an option to have only active racks visibles
- it'd be very useful if the "record on click" option also works with midi/osc remotes
- having an output on objects to be able to display names of drag and drop binds and not only buses

Thank you very much

interesting suggestions,
I'll study them carefully.

Very interesting wishes.
Thank you.

in the next release major release


- possibility to move the devices in the devices menu ; to sort them as needed, and also because Usine chooses by default the 1st device as output
OK

- being able to move a section in the grid by «affecting» the new location, rather than by sliding (complicated when long grid)
OK

- in patch settings , having a «reduce patch» input; there are two minimize inouts but no reduce ("-" in header)
OK

- being able to open several patches windows simultaneously (convenient for comparing, searching ...) > probably very complicated but we never know...
not sure...

- in audio samplers modules, a trigger when it comes to end, not only on restart; sometimes more useful than when restart > to change zone markers for example (when you have to trigger somthing before the loop recovery)
The "is playing" output does a good job ?

- already asked , but (for me) indispensable : the possibility to save presets lists
not sure it's possible...

- an option to make the intensity of the LEDs proportional to the signal received
A new "audio-vu-meter-led" module will be created

- mixer: an option to have only active racks visibles
OK

- it'd be very useful if the "record on click" option also works with midi/osc remotes
hard implementation because it is not easy to know when a MIDI flow has stopped... unless wait few seconds

- having an output on objects to be able to display names of drag and drop binds and not only buses
OK

great !

Thank you very much!!!