BrainModular

hi,
i'd like to control my dimmer ( a starway tutelo ) with usine
I ve followed the step by step tutorial from the DMX manual but it doens't work.
i am a dmx newbie so maybe i am missing something.
But it seems simple :
Just Assign a DMX channel to the par created in the light universe in Usine, and program the physical dimmer with this same channel, that's it ?

Hi,
still the problem to use it but furthermore no more recognize by usine
yesterday my enttec open usb dmx was recognized by usine and today no more...
it that a action to do to reset the dmx parameters ?

Hi julien_

yesterday my enttec open usb dmx was recognized by usine and today no more...

rescan device button should make it appear, is the enttec device plugged in the same usb port than yesterday ?

Just Assign a DMX channel to the par created in the light universe in Usine, and program the physical dimmer with this same channel, that's it ?

make sure the plot panel setting is on universe 0 and point to the good device number

Non, toujours rien j'ai ressayé plusieurs fois, sur les deux ports usb, en redemarrant.
rien n'y fait, elle n'est plus reconnu.
Y a t il une manip pour réinitialiser usine à ces "réglages d'usine"

Usine est une application portable, donc il est possible de dezipper le fichier d'origine dans un autre emplacement pour tester une version vierge

et bien non, ça fonctionne toujours pas...

hello,
there is bug on the 068
you have to activate both options in the setup:
- DMX active
- Artnet active

in order to make dmx work properly in USB
will be corrected in the 069
senso+++

ok thanks i will test that

hello,

is the open DMX USB from Enttec is compatible on OSX and does it works on OSX with Usine ?
Thanks in advance,

Batkam