Setup tab Light

Global configuration parameters for ArtNet, sACN and DMX .

The Usine's light engine can manage Enttec Open DMX, Enttec USB pro devices, as well as all ArtNet and sACN devices connected to the Ethernet port.

But on Mac OSX you'll probably have installation troubles with DMXUSB PRO devices. It's generally caused by FTDI drivers conflicts. So in this case you can try the utility app free FTDI Driver Control 1.0.3 to disable the built-in FTDI driver.

rescan devices

Rescans all connected USB DMX devices. Usine can connect up to four devices.

reset devices

Resets all connected devices (shutdown and restart). Use it if you encounter issues.

outputs

List of Connected USB DMX devices to activate inside Usine.

DMX active

Turns the DMX engine ON. Must be activated to run Usine's DMX.

num of plots

Number of actives plots.

ArtNet settings

artNet active

Turns the ArtNet engine ON.

artNet port out

Output port used for the ArtNet communication (send messages). By default the port is 6454.

artNet in active

Activates the reception of ArtNet messages in Usine. To get messages use the light-artnet-sacn-input.

ArtNet port in

Input port used for the ArtNet communication (get incoming messages). By default the port is 6454.

ArtNet automatic poll

When ON Usine's, Usine will automatically send 'ArtNet Poll' data to retrieve all connected devices.

poll ArtNet

Sends an 'ArtNet Poll' data manually, useless if ArtNet automatic poll is ON.

artNet devices

List of all connected ArtNet devices.

sACN settings

sACN active

Turns the sACN engine ON.

sACN port out

Output port used for the sACN communication (send messages). By default the port is 5568.

sACN in active

Activates the reception of sACN messages in Usine. To get messages use the light-artnet-sacn-input.

sACN port in

Input port used for the sACN communication (get incoming messages). By default the port is 5568.

Global settings

DMX frame rate

Sets the maximum DMX frame rate (packets sent per second). Usine will send packets only if necessary.

clear on stop

Clears all DMX parameter set as "master" when the engine is turned OFF (Blackout).

See also

version 6.0.240115

Edit All Pages